MANUAL FOR UNIQUE EQUIPMENT
This manual is intended for those who refuse to realize that they are holding unique equipment, which has been developed and perfected over the course of 15 years. Study this manual carefully before you start working.
When you receive the device, your very first obligation is to fully charge it, and only then attempt any kind of activation.
If the battery is dead, the device won't allow full activation, and all your attempts will look like idiotic nonsense. This is analogous to trying to drive a car with an absolutely empty tank — from the outside, to put it mildly, it looks ridiculous. Those who intend to keep "driving on an empty tank" can stop reading right here, as this won't help you anyway: first and foremost, the device must be charged.
Unlocking the Device
After a full charge, the device must be unlocked. This is done in one of two ways:
Perform 4 elongated presses with minimal pauses between them.
Or perform a single hold of the button, timing it with a stopwatch for 8 to 9 seconds.
Confirmation
The device will notify you of a successful unlock with a triple vibration. This means exactly that the device has been unlocked and is ready for use.
Activating Modes (AM and RF)
Depending on exactly which button you used to unlock this "2-in-1" jammer, the generation of the corresponding signal will automatically activate.
Right Button
If you unlocked the device using the right button, the Radio Frequency (RF) jammer is activated.
Left Button
Accordingly, unlocking with the left button will start the Acousto-Magnetic (AM) signal generation.
Indication and Standby Mode
Assuming you actually listened and charged the device, it will begin to vibrate periodically, as described in the manual.
- Jamming Mode: A single periodic vibration indicates that the device is currently in suppression (jamming) mode.
- Entering Standby: To switch the device to standby mode, you need to hold this same button for a couple of seconds, and then release it.
- Confirmation: A fading vibration will occur. The device is now in standby mode, allowing you to continue using it based on the data in the manual.
Advanced Settings
For the especially stubborn and those who don't want to study anything, we provide the following information on how to turn the device on in the primary modes right after unlocking. The equipment has far more capabilities than you can imagine.
Once the device is unlocked and in standby mode (not vibrating, just sitting there), you can perform the following action to activate the AM and RF jammers simultaneously:
- First, press the left or right button 2 times.
- Immediately after that, press the exact same button 4 times.
You repeat the exact same procedure on the second button, and your device is now fully activated in the primary standard modes!
Device Memory and Shutdown
After finishing your work, you can do an elongated press on each button, and the device will enter standby mode.
In the future, to turn the device on in the primary modes, you only need to make 2 presses, and the device is guaranteed to turn on in the first mode. Why? Because the device remembers which mode it was in when it was turned off with a long press.