CHARGING PROBLEMS
Before you start: Do not try this procedure if the case is damaged or swollen, becomes unusually hot, or gives off an unusual smell. Bypassing the circuit board as described below is not standard charging. If you are unsure whether this procedure applies to your model, check with us. Do not leave the device unattended.
If you received a device that behaves like this, I should explain in enough detail and in plain language what happened and how to get out of this situation without sending the device back.
Why this happens
To start with, this can happen because one or both buttons are pressed during shipping. They are not just pressed by accident for a moment; they can end up held down for a long time. In electronic devices, holding a button down for a long time can cause a small current drain that uses up energy. As a result, the device may arrive looking as if it is charged when it is actually very deeply discharged.
And the 100% you see when you plug the device in often does not reflect the actual charge. The reason is that the power bank's own electronics (not our built-in device, but the electronics of the power bank itself) cannot get a reliable reading of how much charge is left or what number to display when the battery is deeply discharged. That is why nothing happens when you press a button.
So why does it vibrate? Power passes through the power bank's electronics to our built-in device, causing it to activate. But it only stays active while you hold the button down. Naturally, you cannot use the device in that state.
How to restore charging
1. Connect a phone
If you want to try to bring the device back to life, the steps are fairly simple. First, to help the power bank's electronics detect that the battery really is discharged, you can plug in something that needs charging, such as your phone. Do not connect another power bank. Use a phone or another device that needs charging, such as a tablet or a music player. This way, the power bank's electronics can register that the battery really is discharged and may reset the internal reading. They may have missed the drop because the battery drained through a button being held down, not through the USB ports or the normal power output path.
In other words, take a regular cable and try charging your phone from this power bank. It will not harm the phone; you do not need to worry about that. Leave them connected for a while so you can make sure the power bank has completely stopped charging your device.
2. Connect a wall charger
Then connect the power bank to a regular charger again. You do not need a high-powered or fast charger for our device. An ordinary 5 V adapter rated at around 2 A will do. That is plenty for charging. And since you have already used it before, I think you know the basics and now have a better idea of what is happening.
3. Hold the buttons down
When you plug the device in, you can also help power get past the limiting logic on the power bank's circuit board. To do this, start holding the buttons down as soon as you connect the charging cable (preferably both at once). Inside our device, the buttons are connected to the batteries through the processor. Holding them down lets current travel along those wires directly from the cable to the battery, bypassing the power bank's electronics and bringing the battery back up to a usable charge more quickly.
Hold the buttons for about 5 to 10 minutes. If your fingers get tired, you can take short breaks; that is not critical. The main thing is not to press too hard: it will not speed things up and can damage the button mechanism.
4. Let the device finish charging
Once the charge has reached the necessary level, the power bank's circuit board will continue charging the battery normally, using its standard charging process. At that point, just leave the device to charge to 100% over the next few hours. The unusual button response you saw earlier, when pressing the right button caused an unexpected vibration, should then go away.
After charging: unlock the device
Once the device is working normally again, the expected behavior is for it not to respond to button presses. This is because it comes back to life in the locked state it was shipped in. You will need to unlock it using one of our standard methods: for example, four extended presses with minimal gaps between them, or one long press lasting four to nine seconds (which may be easier than four extended presses). All of this is covered in the Instructions section of our website, which you have probably already read.